FOR MORE INFORMATION ON OUR BOOTHS
PLEASE CALL : 1-800--466-466-1260

SPRAY BOOTH : CODE COMPLIANCE

OZONE / SPECTRUM : SPECS

   OZONE / TECHNOLOGIES

CONSTRUCTION :
Pre-painted (White In & Out)
Panels Double wall panels insolated 3" thick
Plastic protection for easy handling
Design for strength and easy assembly
Tongue and groove joints

 

MECHANICAL & MOTOR :
[1) - 10HP-3PH-240v exhaust motor
(1) - 10HP-3PH-240v intake motor
(1) - 22" and 1-20" low noise turbine
High capacity exhaust & intake
Directly connected to turbine

 

FILTRATION :
[5] - Exhaust filters
[12] - Intake filters:
EU5 Diffusion media intake filtration
Dry type fiber glass filters: 36"x24"
Fully filtered intake ceiling


MAIN DOOR :
[2) 4'-6" wide x 9' high tubular frame
Man access door: 36" x 84”

 

LIGHTING :
4' light fixtures with 4 fluorescent lamps
(10) upper horizontal light fixtures
(10) lower horizontal light fixtures

 

  

JETDRY :
JETdry is a heating air system designed to accelerate the overall spraying and backing process. Each of the four towers located at the corner of the booth provides four nozzles at a minimum of 3500 CFM, greatly accelerating flash off and curing cycles.

 

SMARTOUCH :
Unlike most control panels which must be installed 3 to 5 feet away from the automotive booth or mixing room, our Speed-Touch LCD is designed to be installed inside the compartment. The Speed-Touch LCD is a digital touch screen that features spray-standby for energy conservation, Spray-On with VFD technology, automotive pressure control and JETdry control.

 

DRAGONFLAME :
Dragon-Flame is an air make-up unit made to work your heater's curing cycle. This product is designed to work in any waterborne or salved-based condition, and is ready to provide the highest quality finishes. Working with the VFD, the Dragon-Flame is able to recycle on bake from 80 to 140 degrees in under seconds! With a 10hp motor for intake, and a 10hp for the exaust, the auto pneumatic air damp.

 

POWERSAVER VFD :
PowerSaver is a variable frequency drive technology designed to work together with the baking cycle, which will overall reduce the exhaust speed and ultimately provide a full curing cycle within the spray booth. The VFD provides pressure control in order to keep the spray booth at a constant positive pressure. These features will overall consume less energy minimizing your costs.